Generator Testing Engineer Job Available in Saudi Arabia

Others

Job Id :1000528809


Description

We would like to hire Indian engineer as Generator testing Engineer reporting to the project Dept.

JD as follow:
A Generator Testing Engineer is typically responsible for planning, supervising, and executing Inspection, Electrical testing, commissioning, troubleshooting, and performance verification of generator rotor and stator of Gas & steam turbine, diesel, gas, or turbine generator systems. Below is a sample Job Description (JD):

Key Responsibilities
Technical Duties
A. Inspections & testing generator Stator:
• Inspect the Stator Core/Slot Wedges for condition of the wedges, hot spots & damaged punching.
• Conduct wedge integrity test and submit wedge mapping and reports.
• Inspect end windings, coil for looseness or movement of end winding bracing support blocks, spacers brackets, support rings supporting studs, and the twine lashing and repair Condition of the coil surface, check of winding soaking with oil, clean and apply varnish if necessary.
• Inspect the Core and Magnetic End Shield for:
• Apply varnish if necessary.
• Inspect Bolts, Nuts Locking Devices, etc.
• IR&PI Test
• Tan delta & capacitance Analysis
• Partial discharge test
• HI-POT Test

B. Inspection of Generator Rotor:
• Inspect the winding under the retaining rings for general cleanliness, evidence for movements of the insulation etc. /clean (by fiberscope).
• Inspect the retaining rings for evidence of excessive heating between the retaining ring and the rotor body.
• Inspection and testing of rotating diode assembly, especially fuses and diodes.
• Inspect the movement of the balance weights and locking devices.
• Inspect the retaining rings for stress corrosion cracking by using Dye Penetrant inspection
• Hydrogen leakage test on the connections between rotor winding and axial bore center rods.
• Verify the integrity of rotor ground detection equipment.
• IR&PI Test
• AC impedance test
• RSO
C. Inspection& Testing of Exciter
• Inspect the main and pilot exciter stators
• Inspect the exciter rotor
• Inspect the PMG
D- Additional preferred experience
• Generator commissioning and troubleshooting.
• Load bank testing.
• Synchronization and load sharing.
• Protection relay testing.
• Switchgear and ATS testing.
• Reading electrical schematics and single-line diagrams.
• Use of testing instruments:
o Multimeters
o Power analyzers
o Insulation resistance testers (Megger)
o Primary/secondary injection test sets
Qualifications
• Diploma or bachelor’s degree in electrical engineering, Electromechanical Engineering, or related field.
• Certification in generator commissioning or testing is preferred.
• Knowledge of relevant electrical standards (IEC, IEEE, NFPA, etc.).
• Valid driving license may be required depending on location.
Experience
• 3–8 years of experience in generator testing, commissioning, or power generation.
Soft Skills
• Leadership and team management.
• Problem-solving and analytical skills.
• Technical reporting.
• Communication and coordination.
• Time management.

Basic Details

Location : Region: Riyadh

Qualification :

Posted :

Job Type : Full-Time

Company : Saudi Jobs

Contact Info

Mobile : Not-Mentioned

Alternate Mobile : Not-Mentioned

Email : asbhrrecruitment@gmail.com

By using our site, you acknowledge that you have read and understand our Cookie & Privacy Policy, and our User Agreement .